Key programming(HONDA_Fit-2007-08)

Remote alarm/central locking

System operation

  • Pressing key LOCK button [1] Fig. 107919 once locks the vehicle.
  • Pressing key LOCK button [1] twice within 5 seconds activates the alarm.
  • Pressing key UNLOCK button [2] once unlocks driver's door only and deactivates alarm.
  • Pressing key UNLOCK button [2] twice within 5 seconds unlocks all doors and tailgate.
  • Pressing key PANIC button [3] for more than 1 second activates panic alarm.
  • Pressing any of the key buttons or turning ignition ON deactivates panic aiarm.
  • If vehicie unlocked and doors not opened within 30 seconds, locks and alarm system are automatically reactivated.

 

Synchronization

When

  • Key remote transmitter battery replaced.

How

  • Press key LOCK button [1] Fig, 107919 or UNLOCK button [2] 5-6 times.
  • Synchronization procedure complete.
  • Check operation of key remote transmitter.

Programming

When

  • Key remote transmitter added or replaced.
  • System malfunction.

How

  • Obtain all keys fitted with remote transmitter.

NOTE: A maximum of 3 key remote transmitters can be programmed.

  • Switch ignition ON.
  • Proceed as follows:

NOTE: Point key remote transmitter at central locking signal control module (located behind LH fascia).

    • Within 4 seconds: Press LOCK button [1] Fig. 107919 or UNLOCK button |2] of first key remote transmitter.
    • Within 4 seconds: Switch ignition OFF.
    • Within 4 seconds: Switch ignition ON.
  • Repeat procedure above twice.
  • Within 4 seconds: Press LOCK button [1] or UNLOCK button [2] of first key remote transmitter.
  • System should now lock and unlock vehicle to indicate programming mode activated.
  • Within 10 seconds:
    • Press LOCK button [1] or UNLOCK button [2] of first key remote transmitter, allowing doors to !ock and unlock once.
    • Press LOCK button [1] or UNLOCK button [2] of each remaining key remote transmitter to be programmed, allowing doors to lock and unlock once as each key remote transmitter is programmed.
  • Switch ignition OFF.
  • Remove key.
  • Check operation of all programmed key remote transmitters.

Immoblizer

System operation

  • System arms after switching ignition OFF.
  • Switch ignition ON.
  • Immobilizer warning lamp illuminates for a few seconds Fig. 22019.
  • If immobilizer warning lamp illuminates for a few seconds then flashes rapidly:
    • Key code not recognized.
    • Remove key and try again.

Programming

When

  • System malfunction.
  • Key/key remote transmitter added or replaced.

How

  • Immobilizer can only be programmed using diagnostic equipment

NOTE: A maximum of 6 keys/koy remote transmitters can be programmed