Key programming(INFINITI_QX56-2004-07)

Remote alarm/central locking

System operation

  • SECURITY warning lamp location: Top of fascia panel.
  • With alarm: When activated, SECURITY warning Samp illuminates for 30 seconds, then flashes at regular intervals.
  • Pressing remote transmitter LOCK button once locks at! doors and activates the alarm.
  • Pressing remote transmitter UNLOCK button once deactivates system and unlocks driver's door only.
  • Pressing remote transmitter UNLOCK button twice within 5 seconds deactivates system and unlocks all doors.
  • Pressing remote transmitter trunk release button for at least 1 second opens the trunk only.

NOTE: Tho trunk release button will not operate with the ignition ON or if the trunk lock is in the release cancel position.

  • Pressing remote transmitter panic button for at least 1 second activates panic alarm with the following functions:
    • Sounds horn.
    • Flashes headlamps.
  • Pressing remote transmitter LOCK, UNLOCK or trunk release button deactivates the panic alarm.
  • Pressing remote transmitter panic button for at least 1 second deactivates the panic alarm.

NOTE: Panic alarm automatically stops after 25 seconds.

Programming

When

  • Remote transmitter added or replaced.
  • System malfunction.

How

NOTE: A maximum of 5 remote transmitt0rs can be programmed.

  • Obtain all remote transmitters.
  • Close all doors.
  • Insert and remove key from the ignition switch more than 6 times within 10 seconds.
  • Indicators will flash twice.
  • Insert key into ignition switch and turn to ACC position.
  • Press any button on first remote transmitter to be programmed.
  • Indicators will Hash twice to confirm correct programming.
  • Oldest remote transmitter code is now erased.
  • To program next remote transmitter:
    • UNLOCK then LOCK vehicle using the LOCK/ UNLOCK switch on the driver's door control panel.
    • Press any button on second remote transmitter to be programmed.
    • Indicators will flash twice to confirm correct programming.
  • Oldest remote transmitter code is now erased.
  • Repeat above procedure to program remaining remote transmitters.
  • To exit programming mode: Open driver's door.
  • Check operation of al! programmed remote transmitters.

NOTE: Remote transmitters can also be programmed using diagnostic equipment.

Immoblizer

System operation

  • SECURITY warning iamp iocation: Top of fascia panel.
  • System arms after switching ignition OFF.
  • If the engine wil! not start, proceed as follows:
    • Remove ait possible sources of signal interference from key ring.
    • Switch ignition ON for approximately 5 seconds.
    • Switch ignition OFF.
    • Wait approximately 10 seconds.
    • Switch ignition ON for approximately 5 seconds.
    • Switch ignition OFF.
    • Wait approximately 10 seconds.
    • Start engine.
    • If engine starts: Place source of signal interference elsewhere.
    • If engine does not start: System malfunction.

Programming

When

  • Key added or replaced.
  • System malfunction: Switch ignition ON, SECURITY warning lamp illuminates continuously.

How

  • Immobilizer can only be programmed using diagnostic equipment.
  • Obtain ali keys to be programmed.

NOTE: A maximum of 5 keys can be programmed.